The basic components of an internal-combustion engine are the engine block, cylinder head, cylinders, pistons, valves, crankshaft, and camshaft. The lower part of the engine, called the engine block, houses the cylinders, pistons, and crankshaft. The components of other engine systems bolt or attach to the engine block. The block is manufactured with internal passageways for lubricants and coolant. Engine blocks are made of cast iron or aluminum alloy and formed with a set of round cylinders.
The upper part of the engine is the cylinder head. Bolted to the top of the block, it seals the tops of the cylinders. Pistons compress air and fuel against the cylinder head prior to ignition. The top of the piston forms the floor of the combustion chamber. A rod connects the bottom of the piston to the crankshaft. Lubricated bearings enable both ends of the connecting rod to pivot, transferring the piston’s vertical motion into the crankshaft’s rotational force, or torque. The pistons’ motion rotates the crankshaft at speeds ranging from about 600 to thousands of revolutions per minute (rpm), depending on how much fuel is delivered to the cylinders.
Fuel vapor enters and exhaust gases leave the combustion chamber through openings in the cylinder head controlled by valves. The typical engine valve is a metal shaft with a disk at one end fitted to block the opening. The other end of the shaft is mechanically linked to a camshaft, a round rod with odd-shaped lobes located inside the engine block or in the cylinder head. Inlet valves open to allow fuel to enter the combustion chambers. Outlet valves open to let exhaust gases out.
A gear wheel, belt, or chain links the camshaft to the crankshaft. When the crankshaft forces the camshaft to turn, lobes on the camshaft cause valves to open and close at precise moments in the engine’s cycle. When fuel vapor ignites, the intake and outlet valves close tightly to direct the force of the explosion downward on the piston.
No comments:
Post a Comment